ISO INTERNATIONAL STANDARD 10110-14 Third edition 2018-11 Optics and photonics Preparation of drawings for optical elements and systems Part 14: Wavefront deformation tolerance OptiqueetphotoniquePréparationdesdessinspourélémentset systemesoptiques Partie14: Tolerance dedéformation dufront d'onde Reference number IS0 10110-14:2018(E) ISO @ IS0 2018 IS010110-14:2018(E) COPYRIGHTPROTECTEDDOCUMENT IS02018 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either IsO at the address below or IsO's member body in the country of the requester: ISO copyright office CP 40i : Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +4122.749 0111 Fax: +41 22 749 09 47 Email:[email protected] Website: www.iso.org Published in Switzerland ii IS02018-Allrights reserved IS010110-14:2018(E) Contents Page Foreword iv Introduction. V 1 Scope. .1 2 Normativereferences .1 3 Terms and definitions .1 4 Specification oftolerances for wavefrontdeformation 1 4.1 General. 1 4.2 Units.. 2 4.3 Wavelength. 3 4.4 Target aberrations 3 5 Indication in drawings. 3 5.1 General. 3 5.2 3 Codenumber 5.2.1 Basicforms 3 5.2.2 Additionalforms 5 5.3 Area.. 6 5.4 Location 6 5.5 Indication of the object point location. 8 5.6 Specificationoftheimagepointlocation 9 5.7 Indication oftargetaberrations. 6 6 Examples oftoleranceindications 9 Bibliography .12 @ IS0 2018 - All rights reserved iii