2587 NTERNATIONAL STANDARD (Tso INTERNATIONAL ORGANIZATION FOR STANDARDIZATION MEKIYHAPOAHA OPIAHH3AUHA HO CTAHIAPTH3ALIHH.ORGANISATION INTERNATIONALE DE NORMALISATION Side and face milling cutters with plain bore and key drive - Metric series First edition - 1972-12-01 ISO 2587-1972 (E) UDC 621.914.28 Ref. No. ISO 2587-1972 (E) Descriptors : tools, cuttingtools,millingcutters,dimensions. Price based on 1 page Copyright International Organization for Standardization Not for Resale No FOREWORD IsO (the International Organization for Standardization) is a worldwide federation of national standards institutes (ISO Member Bodies). The work of developing International Standards is carried out through ISO Technical Committees. Every Member Body interested in a subject for which a Technical Committee has been set governmental and non-governmental, in liaison with iso, also take part in the work. Draft International Standards adopted by the Technical Committees are circutated to the Member Bodies for approval before their acceptance as International Standards by the ISO Council. International Standard ISO 2587 ?was drawn up by Technical ( Committee ISO/TC 29, Small too/s. It was approved in February 1972 by the Member Bodies of the following countries : Austria Itaiy Switzerland Japan Turkey Belgium Egypt, Arab Rep. of Poland United Kingdom Romania France U.S.A. Hungary South Africa, Rep. of U.S.S.R. India Spain Israel Sweden The Member Body of the following country expressed disapproval of the document on technical grounds : Czechoslovakia @ International Organization for Standardization, 1972 Printed in Switzerland Copyrightlnternational Oorganization for Standardization Not for Resale working permitted without license from IHS INTERNATIONAL STANDARD ISO 2587-1972 (E) Side and face milling cutters with plain bore and key drive -- Metric series 1 SCOPE AND FIELD OF APPLICATION This international Standard specifies the dimensions of metric series side and face milling cutters with plain bore and key drive, intended for fitting to cutter arbors. It is applicable to cutters with straight teeth and cutters with double alternate helix (staggered tooth) The range of outside diameters of these cutters is taken from ISO/R 523, Recommended range of outside diameters for milling cutters. 2 REFERENCE ISO/R 240, Interchangeability dimensions for milling cutters and cutter arbors or cutter mandrels - Metric series and inch series. 3 DIMENSIONS D FIGURE 1 Cutter with straight teeth FIGURE 2 -- Cutter with double alternate helix L d1 k11 is16 H7 min, 10 12 16 50 16 27 22 80 27 100 32 125 32 47 160 40 55 200 40 55 The bore and keyway dimensions shall be in accordance with the metric series of IsO/R 240. Copyright International Organization for Standardization ed without license from IHS Not for Resale