ISO/TR TECHNICAL REPORT 8100-24 Firstedition 2016-12-15 Safety requirements for lifts (elevators) - Part 24: Convergence of lift requirements Exigences de sécurite pour ascenseurs- Partie 24: Convergence des exigences pour ascenseurs Reference number IS0/TR8100-24:2016(E) ISO Intemational Organization for Standardization @IS02016 ted without license from IHS IS0/TR8100-24:2016(E) COPYRIGHTPROTECTEDDOCUMENT IS02016,Published inSwitzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8. CP 401 CH-1214 Vernier, Geneva, Switzerland Tel. +41 22 749 01 11 Fax +4122 749 09 47 [email protected] www.iso.org Intemationaibr PrganizationforStandardization networking permited without license from IHS IS0/TR8100-24:2016(E) Contents Page Foreword ..iv Introduction.. 1 Scope.. 2 Normativereferences ..1 3 Termsanddefinitions 4 Comparison of CEN-ASME/CSA-Japanese standardsand prescriptiverecommendations....1 4.1 Doorlocks. .1 4.2 Buffers. 29 4.3 Governors. 41 4.4 Brakes. 55 4.5 Safety gear. .75 Bibliography .98 Inteainal oranzation @stS.2.0.1.6 -All rights reserved iii withoutlicense from IHS