ISO INTERNATIONAL STANDARD 16585 First edition 2002-11-01 Closed end blind rivets with pull mandrel and protruding head A2/sSt Rivets aveugles a rupture de tige a corps fermé, a tete bombée - A2/sSt Reference number AXY ISO 16585:2002(E) ISo @ ISO 2002 THS under Not for Resale ISO16585:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event ?ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56.CH-1211Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland @ ISO 2002 - All rights reserved itted without license from IHS Not for Resale ISO 16585:2002(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 16585 was prepared by Technical Committee ISO/TC 2, Fasteners. Annex A of this International Standard is for information only nafionai Organization for Standardizaionserved ii adizai eworkingmitedwihoutlicenefrmH Not for Resale INTERNATIONALSTANDARD ISO 16585:2002(E) Closed end blind rivets with pull mandrel and protruding head - A2/SSt Scope This International Standard specifies dimensional and mechanical characteristics and application data for closed end blind rivets with break pull mandrel and protruding head, with an austenitic stainless-steel body (A2) and a stainless-steel mandrel (sSt) and with nominal diameters, d, from 3,2 mm up to and including 6,4 mm. 2 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to undated references, the latest edition of the normative document referred to applies. Members of isO and IEC maintain registers of currently valid International Standards. Is0 3269:2000, Fasteners — Acceptance inspection andstuds Iso 14588:2000, Blind riv