ISO INTERNATIONAL STANDARD 16528-2 First edition 2007-08-15 Boilers and pressure vessels - Part 2: Procedures for fulfilling the requirements of ISO 16528-1 Chaudieres et recipients sous pression - Partie 2: Procédure pour repondre aux exigences de IisO 16528-1 Reference number ISO 16528-2:2007(E) @ ISO 2007 ISO 16528-2:2007(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation COPYRIGHTPROTECTED DOCUMENT ISO2007 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ISO2007-All rightsreserved ISO 16528-2:2007(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnical committeehasbeen non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2 The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 16528-2 was prepared by Technical Committee ISO/TC 11, Boilers and pressure vessels This first edition of IsO 16528-2, together with the first edition of IsO 16528-1, cancels and replaces the ISO/TS 16528:2002, which has been technically revised. IsO 16528 consists of the following parts, under the general title Boilers and pressure vessels: Part 1: Performance requirements Part2:ProceduresforfulfillingtherequirementsofIsO16528-1 ganizationfor'Standar ii ISO 16528-2:2007(E) Introduction IsO 16528-1 specifies performance requirements for boilers and pressure vessels. There are commonly used national/regional standards that have a proven history of supporting public safety and have good commercial operating experience. It is the intention of this part of iso 16528 to provide a process to identify national/regional standards that satisfy the performance requirements of isO 16528-1. @ ISo 2007 - All rights reserved INTERNATIONAL STANDARD ISO 16528-2:2007(E) Boilers and pressure vessels - Part 2: Procedures for fulfilling the requirements of IsO 16528-1 1 Scope This part of ISsO 16528 provides a procedure and a standard format for standard-issuing bodies to demonstratethattheirstandardsfulfiltheperformancerequirementsofisO16528-1. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the late