ISO INTERNATIONAL STANDARD 15828 First edition 2004-05-01 Road vehicles Offset frontal impact test procedure Vehicules routiers Mode opératoire d'essai de choc frontal décale Reference number AY ISO 15828:2004(E) ISO @ISO 2004 ISO 15828:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation ? ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ISO2004-Allrights reserved ISO15828:2004(E) Contents Page Foreword 1 Scope. 2 Normative references 3 Terms and definitions. 4 Test facility and equipment.. 3 5 Preparation of test vehicle ... 6 6 Description of test dummy.. 7 Installation of test dummy... 8 Impact response measurements Bibliography .. izalion'ghts reserved ii IS0 15828:2004(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnical committeehasbeen non-governmental, in liaison with iso, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 15828 was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee SC 10, Impact testprocedures @ Iso 2004 - All rights reserved INTERNATIONAL STANDARD ISO 15828:2004(E) Road vehicles Offset frontal impact test procedure 1 Scope that will ensure such tests are conducted under the same conditions. It is applicable to passenger cars and light trucks as defined in ISO 3833 with dummies in front seat positions. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated document (including any amendments) applies. Iso 209-1, Wrought aluminium and aluminium alloys - Chemical composition and forms of products - Part 1: Chemical composition Iso 1176:1990, Road vehicles — Masses — Vocabulary and codes IsO 3833, Road vehicles — Types — Terms and definitions IsO 6487, Road vehicles — Measurement techniques in impact tests - Instrumentation Iso 8721, Road vehicles Measurement techniques in impact tests - Optical instrumentation ISO/TR 12349-1, Road vehicles - Dummies for restraint system testing - Part 1: Adult dummies FMVSS 208, Occupant crash protection 1