ISO INTERNATIONAL STANDARD 15822 First edition 2007-06-01 Test method of doorset opening performance in diagonal deformation - Seismic aspects Methode d'essai de la performance d'ouverture des blocs-portes en déformation diagonaleConsiderations sismiques Reference number ISO 15822:2007(E) ISO @ ISO 2007 ISO15822:2007(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimizedforprinting.Every care has been taken to ensure thatthe file is suitableforuse by IsO member bodies. In the COPYRIGHTPROTECTEDDOCUMENT @ISO2007 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's memberbody in the country of the requester. ISO copyright office Casepostale56·CH-1211Geneva20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland = @ ISO 2007 - All rights reserved ISO 15822:2007(E) Contents Page 1 Scope 2 Normative references 3 Terms and definitions . 4 Principle 5 Test specimen 6 Test apparatus 2 7 Test procedure 2 8 Expression of results 7 9 Test report 11 @ ISO 2007 - All rights reserved ili ISO 15822:2007(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with isO, also take part in the work. sO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. adopted by the technical committees are circulated to the member bodies for voting. Publication as an Attention is drawn to the possibility that some of the elements of this document may be the subject of patent ISO 15822 was prepared by Technical Committee ISO/TC 162, Doors and windows. iv ISO 2007-All rights reserved ISO 15822:2007(E) Introduction This International Standard determines the extent to which the opening facility is ensured and retained for ISO 2007 -All rights reserved V ISO 15822:2007(E) INTERNATIONAL STANDARD Test method of doorset opening performance in diagonal deformation Seismic aspects 1 Scope This International Standard specifies the test method for evaluating the opening function of single-leaf doorset under in-plane diagonal deformation by in-plane static load. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated (including any amendments) applies. ISO 1804, Doors - Terminology 3 Terms and definitions For the purposes of this document, the terms and definitions given in IsO 1804 and the following apply. 3.1 in-plane displacement vertical measuring points NOTE In-plane displacement is designated in units of radians. 3.2 opening force force applied to open the door leaf 3.3 unlocking torque value force, in torque value, applied to unlock the doorset 4 Principle The doorset is forced to deform by a static load being gradually applied, and the force necessary to open and unlockthedoorundersuchdiagonaldeformationismeasured 5 Test specimen The test specimen shall be constructed and installed in operating conditions equivalent to normal and practical use. no glass thickness has been specif