IEC INTERNATIONAL STANDARD 62329-1 First edition 2005-11 Heat shrinkable moulded shapes - Part 1: Definitions and general requirements IEC Referencenumber IEC 62329-1:2005(E) Publication numbering As from 1 January 1997 all IEC publications are issued with a designation in the 60000 series.For example, IEC 34-1is now referred to as IEC 60034-1. Consolidated editions The IEc is now publishing consolidated versions of its publications. For example. edition numbers 1.0, 1.1 and 1.2 refer, respectively,to the base publication, the amendments 1 and 2. FurtherinformationonIECpublications The technical content of IEC publications is kept under constant review by the IEC, this.publication, including itsvalidity, is available in the IEc Catalogue of publications (see below) in addition to new editions, amendments and corrigenda. information on the subjects under consideration and work in progress undertaken by the technical committee which has prepared this publication, as well as the list of publications issued, is also available from the following: IEc Web Site (www.iec.ch) Catalogue of IEC publications The on-line catalogue on the IEC web site (www.iec.ch/searchpub) enables you to search by a variety of criteria including text searches, technical committees and date of publication. On-line information is also available on recently issued publications, withdrawn and replaced publications, as well as corrigenda. IEC Just Published This summary of recently issued publications (www.iec.ch/online news/ justpub) is also available by email.Please contact the Customer Service Centre (see below) forfurther information. Customer Service Centre If you have any questions regarding this publication or need further assistance. please contact the Customer Service Centre: Email: [email protected] Tel: +41 22 919 02 11 +41229190300 Fax: IEC INTERNATIONAL STANDARD 62329-1 First edition 2005-11 Heat shrinkable moulded shapes Part 1: Definitionsandgeneral requirements @ IEC 2005—Copyright -all rights reserved mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Electrotechnical Commission, 3, rue de Varembe, PO Box 131, CH-1211 Geneva 20, Switzerland r IEC PRICECODE Commission Electrotechnique Internationale InternationalElectrotechnical Commission MekAyHapoAHag3nekTpoTexHuyeckagKoMuccug For price, see current catalogue - 2 - 62329-1@IEC:2005(E) INTERNATIONALELECTROTECHNICALCOMMISSION HEATSHRINKABLEMOULDEDSHAPES Part 1:Definitions and general requirements FOREWORD (I all national ,electrotechnical committees (IEC National Committees)..The,object of IEC is to.promote this end and in addition to other activities,IEc publishes International Standards,Technical Specifications. Technical Reports, Publicly Available Specifications (PAS)and Guides (hereafter referred to as "TEC Publication(s)"). Their preparation is entrusted to technical committees; any IEC National Committee interested in the subject dealt with may .participate in this preparatory work. International, governmental and non- with the International Organization for Standardization (IsO) in accordance with conditions determined by agreement between the two organizations. The formal decisions or agreements of IEC on technical matters express, as nearly as possible, an international 2) interestedIECNational Committees. 3) IEC Publications have the form of recommendations for international use and are accepted by IEc National Publications is accurate, IEC cannot be held responsible for the way in which they are used or for any misinterpretation by any end user. between any IEc Publication and the corresponding national or regional publication shall be clearly indicated in the latter. 5) IEc provides no marking procedure to indicate its approval and cannot be rendered responsible for any equipment declared to be in conformity with an IEC Publication. All users should ensure that they have the latest edition of this publication. (9 No liabil