BS EN62952-2:2016 IEC62952-2:2016IEC2016 -5- INTRODUCTION ThisPart2of IEC62952deals witha powermodulebasedonbatteries.It providesone Standards.Itdoes notspecify a battery. BS EN62952-2:2016 - 6 - IEC62952-2:2016@IEC2016 POWERSOURCESFORAWIRELESSCOMMUNICATIONDEVICE- Part2:Profileforpowermoduleswithbatteries Scope IEC 62952-2:2016 specifies a profile for a power module containing batteries used as power source for wireless communication devices. 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments)applies. IEC 62952-1:2016,Power sources for a wireless communication device - Part 1:General requirementsofpowersources 3 Terms,definitions,abbreviatedterms,acronymsandconventions 3.1 Terms and definitions Iso and IEC maintain terminological databases for use in standardization at the following addresses: IEC Electropedia:available athttp://www.electropedia.org/ IsoOnlinebrowsingplatform:availableathttp:/www.iso.org/obp 3.2 Abbreviatedtermsandacronyms For the purposes of this document, the abbreviated terms and acronyms given in IE 62952-1 apply. 3.3 Convention for profiles The profile is a selection of (sub)clause of one or more documents defined in tables, as shown in Table 1 and Table 2. The selected base specifications are indicated just before the selection table(s). Selection is done at the highest (sub)clause level possible to define the profile selection unambiguously. Table 1- Layout of profile (sub)clause selection tables Clause Header Presence Constraints BS EN 62952-2:2016 IEC62952-2:2016IEC2016 - 7 - Table2-Contents of (sub)clause selectiontables Column Text Meaning Clause <#> (sub)clause number of the base specifications Next clauses anyfollowing clauses up to the last clause of the base specification Next Annexes any following annexes up to the last annex of the base specification Header <text> (sub)clause title of the base specifications NO Presence This (sub)clause is not included in the profile YES This (sub)clause is fully (100 %) included in the profile in this case no further detail is given Presence is defined in the following subclauses Partial Parts of this (sub)clause is included in the profile Constraints See<#> Constraints/remarks are defined in the given subclause, table or figure of this profile document No constraints other than given in the reference document (sub)clause, or not applicable <text> The text defines the constraint directly, for longer text table footnotes or table notes may beused If sequences of (sub)clauses do not match the profile, then the numbers are concatenated. EXAMPLE 1 concatenated subclauses 3.4 3.7 NO EXAMPLE 2 concatenated clauses up to the last clause Next clauses NO EXAMPLE 3 concatenated annexes up to the last annex Next annexes NO Profileforpowermoduleswithbatteries Thegeneral requirements forthe power modules are specified in IEC 62952-1. Table 3 specifiesa general power module profile selection within IEC62952-1.