EN IEC 60512-99-003 EUROPEANSTANDARD NORMEEUROPEENNE EUROPAISCHENORM November 2023 ICS 13.220.40 English Version Connectors for electrical and electronic equipment - Tests and measurements - Part 99-003: Endurance test schedules - Test 99c: Test schedule for balanced single-pair connectors separating (unmating) under electrical load (IEC 60512-99-003:2023) Connecteurspouréquipements électriques etélectroniques Steckverbinder fur elektrische und elektronische - Essais et mesures - Partie 99-003: Programmes d'essais Einrichtungen - Prufungen und Messungen - Teil 99-003: d'endurance-Essai 99c:Programme d'essai des Dauerprufplane -Prufung 99c: Prufplan fur symmetrische connecteurs a une seule paire symetrique lors de la einpaarige Steckverbinder, die unter elektrischer Last separation (désaccouplement)sous chargeélectrique getrennt werden (IEC 60512-99-003:2023) (IEC60512-99-003:2023) This European Standard was approved by CENELEC on 2023-11-03. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC ManagementCentreortoanyCENELECmember. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notifiedto the CEN-CENELEC Management Centre has the same status as the official versions. CENELECmembers are the nationalelectrotechnical committees of Austria, Belgium,Bulgaria, Croatia, Cyprus, the Czech Republic Denmark, Estonia,Finland,France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands, Norway, Poland, Portugal, Republic of North Macedonia, Romania, Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkiye and the United Kingdom. CENELEC European Committee for Electrotechnical Standardization Comite Europeen de Normalisation Electrotechnique Europaisches Komitee fir Elektrotechnische Normung CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels @ 2023 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members. Ref.No.EN IEC 60512-99-003:2023 E EN IEC 60512-99-003:2023 (E) European foreword The text of document 48B/3058/FDIS, future edition 1 of IEC 60512-99-003, prepared by SC 48B CENELEC as EN IEC 60512-99-003:2023. The following dates are fixed: latest date by which the document has to be implemented at national (dop) 2024-08-03 level by publication of an identical national standard or by endorsement latest date by which the national standards conflicting 2026-11-03 with the(dow) document have to be withdrawn Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights complete listing of these bodies can be found on the CENELEC website. Endorsement notice The text of the International Standard IEC 60512-99-003:2023 was approved by CENELEC as a European Standard without any modification. In the official version, for Bibliography, the following note has to be added for the standard indicated: IEC 60512-99-002 NOTE Approved as ENIEC 60512-99-002 2 EN IEC 60512-99-003:2023 (E) Annex ZA (normative) Normative references to international publications with their corresponding European publications The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. Fol undated references, the latest edition of the referenced document (including any amendments) applies. NOTE 1 Where an International Publication has been modified by c