EN IEC 60966-4-2 EUROPEANSTANDARD NORMEEUROPEENNE EUROPAISCHE NORM August 2022 ICS 33.120.01 English Version Radio frequency and coaxial cable assemblies - Part 4-2: Detail specification for semi rigid cable assemblies (jumper) - Frequency range up to 6000 MHz, type 50-9 semi-rigid coaxial cable (IEC 60966-4-2:2022) Cordons coaxiaux et cordonspourfrequences Hochfrequenz-und Koaxialkabelkonfektionen -Teil 4-2: radioelectriques - Partie 4-2: Specification particuliere pour Bauartspezifikation fur halbstarre Kabelkonfektionen les cordons semi-rigides (jarretieres)-Plage de frequences (Rangierkabel), Frequenzbereich bis 6 000 MHz, Typ 50-9 jusqu'a 6 000 MHz, cable coaxial semi-rigide de type 50-9 halbstarre Koaxialkabel (IEC 60966-4-2:2022) (IEC 60966-4-2:2022) This European Standard was approved by CENELEC on 2022-08-01. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national standards may be obtained on application to the CEN-CENELEC Management Centre or to any CENELEC member. This European Standard exists in three official versions (English, French, German). A version in any other language made by translation under the responsibility of a CENELEC member into its own language and notified to the CEN-CENELEC Management Centre has the same status as the official versions. CENELEC members are the national electrotechnical committees of Austria, Belgium, Bulgaria, Croatia, Cyprus,the Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, the Netherlands,Norway,Poland,Portugal, Republic of NorthMacedonia,Romania,Serbia, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkiye and the United Kingdom. CENELEC European Committee for Electrotechnical Standardization Comite Europeen de Normalisation Electrotechnique Europaisches Komitee fir Elektrotechnische Normung CEN-CENELEC Management Centre: Rue de la Science 23, B-1040 Brussels @ 2022 CENELEC All rights of exploitation in any form and by any means reserved worldwide for CENELEC Members. Ref. No. EN IEC 60966-4-2:2022 E EN IEC 60966-4-2:2022 (E) European foreword The text of document 46/882/FDIS, future edition 1 of IEC 60966-4-2, prepared by IEC/TC 46 "Cables wires, waveguides, RF connectors, RF and microwave passive components and accessories" was submitted to the IEC-CENELEC parallel vote and approved by CENELEC as EN IEC 60966-4-2:2022. The following dates are fixed: latest date by which the document has to be implemented at national (dop)2023-05-01 latest date by which the national standards conflicting with the (dow)2025-08-01 document have to be withdrawn Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CENELEC shall not be held responsible for identifying any or all such patent rights complete listing of these bodies can be found on the CENELEC website. Endorsement notice The text of the International Standard IEC 60966-4-2:2022 was approved by CENELEC as a EuropeanStandardwithoutanymodification 2 EN IEC 60966-4-2:2022 (E) Annex ZA (normative) Normative references to international publications with their corresponding European publications The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. Fol undated references, the latest edition of the referenced document (including any amendments) applies. NOTE 1 Where an International Publication has been modified by common modifications, indicated by (mod), the relevant EN/HD applies. NOTE2Up-to-date informationonthe latest versionsof the European Standards listed inthisannexis available here: www.cenelec.eu Publication EN/HD Yea